[edit vpn ipsec site-to-site peer set tunnel 1 local prefix 10.181.XX.XX/19 // Vyatta Private subnet IP [edit vpn ipsec site-to-site peer set local-address .XX // Public IP of the Vyatta router appliance [edit vpn ipsec site-to-site peer set ike-group IKE-RS [edit vpn ipsec site-to-site peer set default-esp-group ESP-RS [edit vpn ipsec site-to-site peer set authentication pre-shared-secret test_test_111 // Use the same in key at Fortigate end +interface set vpn ipsec ike-group IKE-RS proposal set vpn ipsec ike-group IKE-RS proposal 1 encryption set vpn ipsec ike-group IKE-RS proposal 1 hash set vpn ipsec ike-group IKE-RS proposal 2 encryption set vpn ipsec ike-group IKE-RS proposal 2 hash set vpn ipsec ike-group IKE-RS lifetime set vpn ipsec esp-group ESP-RS proposal set vpn ipsec esp-group ESP-RS proposal 1 encryption set vpn ipsec esp-group ESP-RS proposal 1 hash set vpn ipsec esp-group ESP-RS proposal 2 encryption set vpn ipsec esp-group ESP-RS proposal 2 hash set vpn ipsec esp-group ESP-RS lifetime 3600Ĭonfigure the IPsec connection key and DDNS settings, as shown in theįollowing example: set vpn ipsec site-to-site peer authentication mode pre-shared-secret // Replace with your DDNS edit vpn ipsec site-to-site peer $configure //Move to configuration set vpn ipsec ipsec-interfaces interface show vpn ipsec ipsec-interfaces Log in to the Vyatta server by using Secure Shell (SSH), as shown in theįollowing example: $ssh show interfaces ethernet //Get interface IP details
Use the following steps to configure the IPsec VPN in the Vyatta router Step 1: Configure the IPsec VPN in the Vyatta router appliance Name in FortiGate, see How to set up DDNS on a FortiGate device. Internal: 192.168.10.0/24 (local area network (LAN) subnet)Īfter you successfully establish a site-to-site IPsec VPN tunnel connectionīetween Vyatta and FortiGate, you can ping the Vyatta router’s private IPĪddress (such as 10.) from any internal IP addressįortiGate enables you to create a DDNS name.
Point B (FortiGate with a dynamic IP address and DDNS name)ĭevice: Vyatta router appliance at Rackspace Router appliance) and the right side (FortiGate with aĭynamic IP address and DDNS name) as point B: Point A (Vyatta router) The following table shows the left side as point A (the Rackspace Vyatta However, the Vyatta serverĪppliance has an option to configure a DDNS name to configure a Static Internet Protocol (IP) address on both ends. Configuring an IPsec VPN between two end points typically requires a (Rackspace) and FortiGate® by using a dynamic Domain Name System (DDNS) (IPsec) virtual private network (VPN) connection between a Vyatta® router This article shows you how to create a site-to-site Internet Protocol Security
0 kommentar(er)
